The wear and tear of the table is experienced through cracks in the slate below the felt. There are a number of tips that are useful when it comes to repair of billiards and restoring it back to its condition. Repairs are better attended to after separating the felt and the table. In so doing, the repairs will be done in a more comprehensive manner. A socket wrench will be required for this exercise. It is used to remove the bolts that attach the rails to the table.
After the rails have been removed, the next thing is to remove the staples attaching the felt to the table. The best tool would be a staple puller but a screwdriver may also be used. The screwdriver needs to have a head that is flat. The removed staples should be kept carefully on the side because they may cause injury if one steps on them. They may also be misplaced.
The slate needs inspection to determine the extent to which it has been affected by cracks. Beeswax is used to fill in the cracks and small chips. The wax is held four inches above the crack then it is melted through the use of a small portable torch that uses propane. The wax is left to drip into the crack.
Slate normally requires a lot of wax to bond effectively. After the wax has cooled well, a paint scraper is used to remove any excess wax. The excess wax needs to be removed because it will lead to the slate having an unpleasant appearance. The wax should also be placed carefully and in the right amounts so that it dries up and fills the cracks more effectively.
Billiard table wax can also be used. It has resin that makes it to harden much better than beeswax. This gives more durable results. Billiard wax is better in the event that the cracks are considerably big. Like in the case of beeswax, there will be excess wax that should be gotten rid of. After removing the excesses, it is important to wipe the slate with damp cloth or sponge. Billiard wax also comes in handy when you have to seal loose seams on slate.
For even more extensive cracks, slate repair glue is used. It is thick and consistent, features that make it able to effectively bond slate. The glue is applied inside the cracks on both sides. The separate sides are then firmly pushed together. For the glue to bond the separate slate pieces, they are held together for some time.
The pressure that results from the slate being pushed together makes some glue to seep out. It ought to be left to dry. After that, it is smoothed using sandpaper. The felt is put back in position after all repairs are done.
Useful Information On Billiards Repair Denver
via First For All http://ift.tt/1BC5FwV